Technical drawings for Trinity Mounting System?
Hello.
I am looking for a technical drawing for the Trinity Mounting System.
I am building electric roller skis and I think that the boots available for the Trinity Mounting System might fit the bill. However, I need to get the exact dimensions of the holes in order to correctly CNC the surface of the ski.
Is anyone able to help me find such a drawing?
Thank you.
Comments
Check with Jimmy Blair at Pinnacle Skates. He has build custom boots for Trinity frames and might have what you need.
Indoor Inline: Pinnacle Full Customs | Junk Fury 4x110 | TLTF/Simmons Wheels | NMB
Outdoor Inline: Simmons Full Customs | Junk Fury 4x110 | Junk Wheels | NMB
Quads: Reidell 911 | Roll-Line Giotto | Corey Super-Ds/JG Hubs/B-Skater 71mm Outdoor | Bones Swiss/NMB
You should be able to get a set of Trinity adapters fairly inexpensively, then transfer the dimensions.
The_Snowman, you mean pinnacleracing.com, correct? I submitted a contact form. Tried calling too, but no answer. Fingers crossed. Thanks!
DocSk8, thanks for the tip--I'll keep that in mind. I'm hoping for an original drawing so I don't get it slightly off. Being off by even 1mm could make it hard to fit screws in, and I know the Trinity bindings have a height offset for the heal, meaning that I have be correct in three dimensions.